Section 124 (Starting System (Service Information)): Starter: Installation: 5.7L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Starter Motor & Bolts

Courtesy of CHRYSLER GROUP, LLC

Connect the solenoid wire to the starter motor (snaps on).
Position the battery cable to the solenoid stud. Install and tighten the battery cable eyelet nut. Torque nut to 25 N.m (19 ft. lbs.). Do not allow the starter motor to hang from the wire harness.
Position the starter motor (1) to the engine.
If equipped with automatic transmission, slide cooler tube bracket into position.
Install and tighten both mounting bolts (2). Torque bolts to 54 N.m (40 ft. lbs.).
Lower the vehicle.
Connect the negative battery cable.