LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Starting System (Service Information)) >> Starter >> Installation >> 3.6L W/Ess

3.6L W/Ess

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the starter to the transmission bell housing.
    Fig 1: Starter Mounting Bolts
    GC0173590Courtesy of CHRYSLER GROUP, LLC
  2. Install the starter mounting bolts (1).
    Fig 2: Solenoid Stud, Battery Cable Nuts & Connector
    GC0173661Courtesy of CHRYSLER GROUP, LLC
  3. Connect the starter solenoid electrical connector to starter solenoid terminal (2).
  4. Connect the starter solenoid and secure with nuts (1, 3).
  5. Install the starter solenoid heat shield.
  6. Install the front suspension skid plate. Refer to PLATE, SKID, FRONT SUSPENSION, INSTALLATION .
  7. Install the front skid plate. Refer to PLATE, SKID, FRONT, INSTALLATION .
  8. Install the left engine mount. Refer to INSULATOR, ENGINE MOUNT, LEFT, INSTALLATION .
scientia non olet · About LEMON Manuals