LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Power Locks (Service Information)) >> Antenna, Passive Entry >> Removal >> Rear Door

Rear Door

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Low Frequency Antenna Connector Receptacle, Screws, Antenna & Carrier Plate
GC0145746Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the trim panel from the inside of the rear door. Refer to PANEL, REAR DOOR TRIM, REMOVAL .
  3. Disconnect the door wire harness connector from the Low Frequency (LF) antenna connector receptacle (2).
  4. Remove the two screws (1) that secure the LF antenna (4) to the rear door hardware carrier plate (3).
  5. Remove the LF antenna from the rear door.