LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Power Locks (Service Information)) >> Antenna, Passive Entry >> Installation >> Rear Door

Rear Door

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Low Frequency Antenna Connector Receptacle, Screws, Antenna & Carrier Plate
GC0145746Courtesy of CHRYSLER GROUP, LLC
  1. Position the Low Frequency (LF) antenna (4) to the rear door hardware carrier plate (3).
  2. Install and tighten the two screws (1) that secure the LF antenna to the carrier. Tighten the screws securely.
  3. Reconnect the door wire harness connector to the LF antenna connector receptacle (2).
  4. Reinstall the trim panel onto the inside of the rear door. Refer to PANEL, REAR DOOR TRIM, INSTALLATION .
  5. Reconnect the battery negative cable.