When Monitored And Set Conditions
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
This diagnostic runs continuously when the following conditions are met:
- All ignition positions.
- During the Passive Entry or Keyless Go event.
- Battery voltage is between 10.0 - 16.0 volts.
- Smart sensor is present on the Door Handle.
Set Conditions:
- Whenever the Radio Frequency Hub (RF Hub) detects an open, a short to ground or a short to battery on the Passive Handle Switch Sense circuit for approximately (2) minutes, this code will set.
Default Actions:
- Must use RKE or bladed key to enter the vehicle.
| Possible Causes |
|---|
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT SHORTED TO VOLTAGE |
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT SHORTED TO GROUND |
| FRONT RIGHT PASSIVE HANDLE SWITCH RETURN CIRCUIT OPEN |
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT OPEN |
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT SHORTED TO THE FRONT RIGHT PASSIVE HANDLE SWITCH RETURN CIRCUIT |
| FRONT RIGHT EXTERIOR DOOR HANDLE (PASSIVE ENTRY) |
| RADIO FREQUENCY HUB (RF HUB) |