Switch, Heated Seat: Removal: Rear

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Take the proper precautions to protect the face of the floor console panel from cosmetic damage while performing this procedure.

Fig 1: Floor Console Rear Trim Panel, Six Screws & Secure Floor Console Rear Duct

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the floor console rear trim panel (1) from the back of the floor console using Trim Stick (special tool #C-4755, Trim Stick) or equivalent. Disconnect any necessary electrical connectors and place the trim panel on a workbench.
Remove the six screws (1 and 3) that secure floor console rear duct (2) to the floor console rear trim panel (4).
NOTE:
If the foam seal on the console rear duct is deformed or damaged, the seal must be replaced.
Remove the floor console rear duct from the floor console rear trim panel.

Fig 2: Trim Stick, Two Retaining Tabs & Floor Console Rear Trim Panel
Courtesy of CHRYSLER GROUP, LLC
Using Trim Stick (special tool #C-4755, Trim Stick) or equivalent, gently disengage the two retaining tabs (1 and 3) that secure each 2nd row heated switch (2) to the back of the floor console rear trim panel (4).
Remove the 2nd row heated switches, as necessary, from the floor console rear trim panel.