Driver Seat Without Memory Seat System
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Remove the power seat switch from the seat. Refer to SWITCH, SEAT, REMOVAL .
- Use an ohmmeter to test the continuity of the power seat switch using the following table. If not OK, replace the inoperative power seat switch. If switch tests OK, check for an open or short in the power seat circuit wiring. If no open or short is found, replace the power adjuster motor(s) as required.
DRIVER SEAT SWITCH CONTINUITY - WITHOUT MEMORY
| SWITCH POSITION | CONTINUITY BETWEEN |
|---|---|
| OFF | 7-1, 7-3, 7-4, 7-5, 7-8, 7-9, 7-10, 7-11 |
| RECLINER UP | 6-3, 7-1, 7-4, 7-5, 7-8, 7-9, 7-10, 7-11 |
| RECLINER DOWN | 6-1, 7-3, 7-4, 7-5, 7-8, 7-9, 7-10, 7-11 |
| HORIZONTAL FORWARD | 6-8, 7-1, 7-3, 7-4, 7-5, 7-9, 7-10, 7-11 |
| HORIZONTAL REARWARD | 6-4, 7-1, 7-3, 7-5, 7-8, 7-9, 7-10, 7-11 |
| FRONT TILT DOWN | 6-5, 7-1, 7-3, 7-4, 7-8, 7-9, 7-10, 7-11 |
| FRONT TILT UP | 6-9, 7-1, 7-3, 7-4, 7-5, 7-8, 7-10, 7-11 |
| REAR TILT DOWN | 6-10, 7-1, 7-3, 7-4, 7-5, 7-8, 7-9, 7-11 |
| REAR TILT UP | 6-11, 7-1, 7-3, 7-4, 7-5, 7-8, 7-9, 7-10 |