Unit, Front Lamp: Removal: Lamp
Courtesy of CHRYSLER GROUP, LLC
- Disconnect and isolate the battery negative cable.
- Loosen the front fascia on the same side of the vehicle as the front lamp unit being removed. Refer to FASCIA, FRONT, REMOVAL
.
- Remove the four plastic push-pin fasteners that secure the upper grille to the Front End Module (FEM).
- Flex the fascia and grille (1) outward far enough to access and remove the three screws (2) that secure the front lamp unit to the FEM.
- Pull the front lamp unit away from the FEM far enough to access and disconnect the headlamp and dash wire harness connectors from the back of the lamp housing.
- Remove the front lamp unit from the vehicle.