Lamp, Tail Stop Turn: Removal: Lamp: Outer
Courtesy of CHRYSLER GROUP, LLC
- Disconnect and isolate battery negative cable.
- Open the liftgate to access and remove the two push pin fasteners (2) that secure the inboard side of the outer rear lamp unit (1) to the side jamb of the liftgate opening.
- Pull the outboard side of the outer rear lamp unit rearward far enough to disengage the two locating pins on the back of the lamp housing from the plastic grommets in the lamp opening of the body sheet metal (3).
- Pull the lamp away from the vehicle far enough to access and disconnect the two body wire harness connectors from the LED lighting element and the bulb socket connector receptacles on the back of the lamp housing.
- Remove the lamp from the vehicle.