Diagnostic Test
- DETERMINE ACTIVE OR STORED DTC NOTE:
Make sure the battery is fully charged.
- Turn the ignition on.
- Wait 12 seconds, then with the scan tool, read all active ORC DTCs.
Is the DTC active or stored?
ORC - ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
- Go To 2.
ORC - STORED DTC
- Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM INTERMITTENT TEST.
- CHECK BCM COUNTRY CODE AND VEHICLE LINE
- Using the scan tool, check for the correct Country Code, Vehicle Line, and Body Style.
Does the Vehicle Configuration in the BCM match the Vehicle Configuration in the ORC?
Yes
- Replace the ORC in accordance with Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, REMOVAL .
- Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM VERIFICATION TEST.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
No
- Configure the BCM in accordance with the service information.NOTE:
The ORC Reset Function must be performed after the repair to force the module to retest for this DTC. Access the Miscellaneous Function or Diagnostics Procedures menu from the ORC ECU Overview screen on the scan tool to perform this operation.
- Using the scan tool, check for the correct Country Code, Vehicle Line, and Body Style.