Diagnostic Test
-
- Turn the ignition on.
- With the scan tool, read ORC DTCs.
Is the DTC active or stored?
ORC - ACTIVE DTC
- Replace the ORC in accordance with the Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, REMOVAL .
- Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM VERIFICATION TEST.
NOTE:Make sure the part number of the replacement module is the correct part number for the vehicle.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
ORC - STORED DTC
- Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM INTERMITTENT TEST.
NOTE:
Make sure the battery is fully charged.