LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2012 >> Journey SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (62TE Automatic Transmission (Service Information)) >> Sensor, Pressure Control >> Removal >> Removal

Sensor, Pressure Control: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Relay AT Core Support
GC0122773Courtesy of CHRYSLER GROUP, LLC
  1. Remove the engine cover.
  2. Remove the battery and battery tray. Refer to BATTERY, REMOVAL .
  3. Remove the relay (1) at the core support.
    Fig 2: Identifying Upper Radiator Hose & Clamps
    GC0122774Courtesy of CHRYSLER GROUP, LLC
  4. Drain the radiator. Refer to STANDARD PROCEDURE .
  5. Remove clamps (1) at the upper radiator hose (2).
  6. Remove the upper radiator hose. Refer to STANDARD PROCEDURE .
    Fig 3: Identifying Power Steering Lines & Bolts
    GC0122775Courtesy of CHRYSLER GROUP, LLC
  7. Remove the bolts (1) holding the power steering lines (2).
    Fig 4: Identifying Shift Cable & Manual Valve Lever
    GC0121541Courtesy of CHRYSLER GROUP, LLC
  8. Remove shift cable (1) from manual lever (2).
    Fig 5: Front Sound Dampener Cover & Fasteners
    GC0122507Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Keep the Top Sound Dampener Cover if replacing the unit

  9. Remove the fasteners (1) and the Front Sound Damper Cover (2).
    Fig 6: Identifying Valve Body Oil Pan & Bolts
    GC0122509Courtesy of CHRYSLER GROUP, LLC
  10. Remove the top valve body oil pan (1) bolts.
    Fig 7: Solenoid Connector AT Transmission
    GC0122501Courtesy of CHRYSLER GROUP, LLC
  11. Remove the solenoid pack connector (2) at valve body oil pan (1).
    Fig 8: Identifying Wheel, Opening & Splash Shield
    GC0122776Courtesy of CHRYSLER GROUP, LLC
  12. Raise the vehicle on a hoist.
  13. Remove the front left side inner wheel splash screws from front side of wheel opening (1) and fold shield (2) back.
  14. Turn the wheel (3) fully to the left.
    Fig 9: Identifying Ground Cable, Bolt & Tie Strap
    GC0122777Courtesy of CHRYSLER GROUP, LLC
  15. Remove the bolt (2) at the ground cable (3).
  16. Remove the clip (1) at the valve body pan.
  17. Move cable away from the valve body pan.
    Fig 10: Identifying Pressure Tap Plug & Lower Valve Body Oil Pan Bolts
    GC0122510Courtesy of CHRYSLER GROUP, LLC
  18. Remove the pressure tap plug (2) at valve body oil pan.
  19. Remove the lower valve body oil pan bolts (1) and drain transmission fluid.
  20. Remove the valve body oil pan.
    Fig 11: Identifying Bolts AT Line Pressure Sensor
    GC0122778Courtesy of CHRYSLER GROUP, LLC
  21. Remove the bolts (1) at the line pressure sensor.
  22. Remove the line pressure sensor from the valve body.
scientia non olet · About LEMON Manuals