Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK TO SEE IF DTC P0992 IS CURRENT
NOTE:
The vehicle must be driven to set this DTC. The transmission must be at normal operating temperature with the Engine RPM above 1000 RPM.
1. This DTC is an indication of both the 2/4 and the O/D Hydraulic Pressure Switch DTCs are present.
2. Refer to DIAGNOSTIC CODE INDEX and perform the diagnostic procedures for both P0845 and P0870.
3. With the scan tool, check the Event Data to help identify the conditions in which the DTC was set.
  Repair
  - Refer to DIAGNOSTIC CODE INDEX and perform the diagnostic procedures for P0845 and P0870 .
  - Refer to STANDARD PROCEDURE and perform the appropriate TRANSMISSION VERIFICATION TEST .