Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

WORN OUT/ BURNT TRANSMISSION FLUID
1. Turn the ignition off to the lock position.
2. Flush the Transmission Oil Cooler and lines, replace the Transmission Oil Filter, refill with new Transmission Fluid, start the engine, and adjust the fluid per the Service Information.
  NOTE:
  The Transmission Cooler must be flushed before proceeding.
3. Allow the engine to idle for 10 minutes, in Park.
4. Turn the ignition off to the lock position.
5. Again, flush the Transmission Oil Cooler and lines, replace the Transmission Oil Filter, refill with new Transmission Fluid, start the engine, and adjust the fluid per the Service Information.
6. With the scan tool, perform a Battery Disconnect.
  NOTE:
  The Battery Disconnect must be done to re-enable EMCC during an A/C Clutch engagement.
  
  NOTE:
  The vehicle may exhibit intermittent shudder during the first few hundred miles. The new Transmission Fluid will gradually penetrate the Torque Convertor Clutch friction material and the shudder should disappear.
7. Erase the DTC and return the vehicle to the customer.
  Did the DTC reset and/or does the vehicle still shudder after a few hundred miles?
  
  Yes
  - Replace the Torque Converter per the Service Information.
  - Refer to STANDARD PROCEDURE and perform the 62TE VERIFICATION TEST .
  No
  - Test Complete.