Bezel, Instrument Panel, Center: Removal: Removal

Fig 1: Instrument Panel Outlet Vent/Trim

Courtesy of CHRYSLER GROUP, LLC

Disconnect the negative battery cable.
Using (special tool #C-4755, Trim Stick) or equivalent, remove the instrument panel outlet vent/trim (1). Refer to OUTLET, AIR, FRONT, REMOVAL or OUTLET, AIR, REAR, REMOVAL .

Fig 2: Instrument Panel Trim
Courtesy of CHRYSLER GROUP, LLC
Using (special tool #C-4755, Trim Stick) or equivalent, remove the instrument panel trim (1) located left of the center stack bezel.

Fig 3: Two Screws, Switch-Bank, IP & Clips
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Do not disconnect/connect the ICSS/switch bank without referring to the appropriate procedure. The harness connector is very fragile and could be damaged if not properly removed/installed.
Remove the switch-bank (1) from the I/P (4). Refer to POD, SWITCH BANK, REMOVAL .

Fig 4: Fasteners & Bezel
Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (2) securing the bezel (1) to the I/P.
CAUTION:
Do not disconnect/connect the ICSS/switch bank without referring to the appropriate procedure. The harness connector is very fragile and could be damaged if not properly removed/installed.
Using (special tool #C-4755, Trim Stick) or equivalent, disengage the snap retainers securing the center bezel (1) to the I/P. Do not remove at this time.
Disconnect the integrated center stack screen. Refer to MODULE, INTEGRATED CENTER STACK SCREEN, REMOVAL .
Remove the center stack bezel (1).