Switch, Parking Brake: Removal: Removal: Hand-Operated

Fig 1: Parking Brake Lever

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the battery negative cable.
2. Remove the console from the floor panel. Refer to CONSOLE, CENTER, REMOVAL .
3. Pull the parking brake lever (1) upward to apply the parking brake.
4. Disconnect the wire harness connector from the terminal of the park brake switch (2) located on the right side of the park brake lever mechanism.
5. Remove the screw (3) that secures the switch to the park brake lever bracket.
6. Remove the switch from the park brake lever bracket.