Pod, Switch Bank: Installation: Installation

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Fig 1: Switch-Bank Panel & Electrical Connector

Courtesy of CHRYSLER GROUP, LLC

Position the switch-bank assembly in place.
Connect the electrical connector (2) to the back of the switch-bank assembly (1).

Fig 2: Two Screws, Switch-Bank, IP & Clips
Courtesy of CHRYSLER GROUP, LLC
Position the switch-bank in the IP and press evenly the engage the two lower clips (3).
Install, and tighten the two screws (2) that secure the switch-bank (1) to the IP (4).
Install the IP trim to the left of the switch bank.
Install the instrument panel (IP) right side duct outlet. Refer to OUTLET, AIR, FRONT, INSTALLATION or OUTLET, AIR, REAR, INSTALLATION .
Connect the negative battery cable.