Heated Seat Switch - Installation

INSTALLATION

NOTE: Take the proper precautions to protect the face of the floor console panel from cosmetic damage while performing this procedure.





1. Align the tabs on each 2nd row heated seat switch (1 and 2) with the openings in the floor console rear trim panel (5) and install the switches, as necessary. Push the switches firmly into the trim panel until the two retaining tabs (3 and 4) are fully engaged.
2. Install the trim panel onto the back of the center floor console. Be sure to connect any necessary electrical connectors and properly align the console ducts.
3. Reconnect the negative battery cable.
4. Verify proper 2nd row heated seat system operation.