Installation

INSTALLATION





1. Position the pedal assembly (1) to the mounting studs.
2. Install the pedal assembly 3 retaining nuts (2,3) and tighten to 34 Nm (25 ft. lbs.).





3. Connect both electrical connectors at the APPS (2).
4. Connect the electrical connector at the accelerator pedal adjuster motor (1).





5. Connect the negative battery cable (1).





6. If equipped with adjustable pedals, synchronize the accelerator pedal to the brake pedal and then connect the adjuster cable (1) to the accelerator pedal adjuster motor (2) Brake and/or Accelerator Pedals - Installation.