Removal

REMOVAL





1. Disconnect the negative battery cable.
2. Remove the fuel tank filler cap.
3. Raise and support the vehicle.
4. Remove the right rear tire.
5. Remove the right rear wheelhouse splash shield.





6. Disconnect the ESIM electrical connector (1).
7. Disconnect the fuel tank vapor line (2) quick-connect fitting from the EVAP canister and position aside.
8. Disconnect the vapor purge line (3) quick-connect fitting from the EVAP canister and position aside.





9. Remove the vapor canister retaining nut (1).
10. Lower the front of the vapor canister.
11. Slide the vapor canister forward off of rear mounting brackets.





12. Make sure you do not lose the rear mounting bracket rubber mounts.
13. Remove the vapor canister, ESIM, and fresh air filter from the vehicle as an assembly.