Hydraulic Lifter - Removal

REMOVAL

1. Disconnect and isolate the negative battery cable.
2. Remove the cylinder head Cylinder Head - Removal




3. Remove the tappet guide holder retaining bolt (1) from the tappet guide holder assembly (2).






CAUTION: The lifter and retainer assembly must be installed as a unit.

CAUTION: If the lifter and retainer assembly are to be reused, identify the lifters to ensure installation in their original location or engine damage could result.

4. Remove the tappet guide holder (1) and tappets (2) as an assembly.
5. Check the camshaft lobes for abnormal wear.