LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2012 >> Charger AWD V8-5.7L >> Repair and Diagnosis >> Brakes and Traction Control >> Brake Pedal Assy >> Service and Repair >> Removal and Replacement >> Brake and/or Accelerator Pedals - Installation >> Pedal

Pedal






PEDAL





1. Install adjustable brake pedal assembly (4) under instrument panel and slide over booster push rod.
2. From engine compartment side, push power brake booster (3) mounting studs back through dash panel (2) and brake pedal bracket.
3. Install two upper mounting nuts (1) fastening pedal bracket to upper dash panel (2). Do not tighten at this time.
4. Install four power brake booster mounting nuts (1). Tighten nuts to 25 Nm (18 ft. lbs.) torque.
5. Tighten two upper mounting nuts (1) to 25 Nm (18 ft. lbs.) torque.





6. Slide booster push rod (5) onto brake pedal pin (4). Install NEW retaining clip (3) securing push rod to brake pedal.
7. Install and adjust brake lamp switch (2) Stop Lamp Switch - Installation.

8. Install steering column opening cover Steering Column Opening Cover - Installation.
9. Install driver side silencer under instrument panel Silencer Panel - Installation.





10. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
11. Road test vehicle testing operation of brakes.

scientia non olet · About LEMON Manuals