Rear Door

REAR DOOR





1. Position the Low Frequency (LF) antenna (2) to the rear door hardware module carrier (3). Be certain the door wire harness take out for the antenna is routed behind the antenna, but not pinched.
2. Install and tighten the two screws (4) that secure the antenna to the carrier. Tighten the screws securely.
3. Reconnect the door wire harness connector (1) to the antenna connector receptacle.
4. Reinstall the trim panel onto the inside of the rear door. Rear Door Trim Panel - Installation.
5. Reconnect the battery negative cable.