Rear Shelf Panel - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove the right and left lower and upper C-pillar trim from the vehicle. C-Pillar Trim Panel - Removal.
3. Remove the nut that secures the center rear seat belt lower anchor to the stud on the floor panel and feed the seat belt webbing back through the opening in the top of the rear shelf panel trim (2) to the retractor.
4. Remove the push-pin fastener (1) that secures the trim to the rear shelf panel (3).
5. Slide the trim forward to disengage the S-clip that secures the underside of the trim to the center of the shelf panel.
6. Remove the trim from the rear shelf panel.