Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Challenger SXT, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,Front & Rear | 1.8 | B | ||
| Both Sides,Front or Rear | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed Brake System. | ||||
| Each Additional | 0.2 | B | ||
| One | 0.3 | B | ||
| Combination Procedure: CALIPER: Overhaul: Includes: Bleed Brake System. | ||||
| Dual Piston Calipers,One Side | 0.7 | B | ||
| Single Piston Caliper,One Side | 0.5 | B | ||
| Combination Procedure: CALIPER: Replace: Includes: Bleed Brake System. | ||||
| One,Front or Rear | 0.3 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides | 1.3 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,One Side | 0.5 | B | ||
| Rear,One Side | 0.3 | B | ||