LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2012 >> C/V >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster (Service Information) >> Installation >> Installation - LHD >> Cluster Assembly

Cluster Assembly

Fig 1: Instrument Cluster
GC0147517Courtesy of CHRYSLER GROUP, LLC
  1. Position the instrument cluster (1) close enough to the instrument panel and connect the instrument panel wire harness connector.
  2. Position the instrument cluster mounting tabs to the mounting holes in the instrument panel.
  3. Install and tighten the screws that secure the mounting tabs of the instrument cluster.
  4. Install the instrument panel top pad. Refer to BEZEL, INSTRUMENT CLUSTER, INSTALLATION .
  5. Connect the negative battery cable.
    NOTE:

    Certain indicators in this instrument cluster are automatically configured. This feature allows those indicators to be activated or deactivated for compatibility with certain optional equipment. If a problem is noted that involves improper illumination of an indicator, disconnect and isolate the battery negative cable. After about five minutes, reconnect the battery negative cable and turn the ignition switch to the ON position. The instrument cluster should automatically relearn the equipment in the vehicle and properly configure the configurable indicators accordingly

scientia non olet · About LEMON Manuals