Lamp, Center High Mounted Stop: Removal: Removal

Fig 1: Center High Mounted Stop Lamp & Screws

Courtesy of CHRYSLER GROUP, LLC

NOTE:

The CHMSL illumination on this vehicle is accomplished by LED bulbs and these bulbs are not serviced separately. The CHMSL must be replaced as a unit.

Disconnect and isolate the battery negative cable.
Open the rear liftgate, and disconnect the washer hose from the CHMSL unit.
Remove the liftgate spoiler assembly. Refer to SPOILER, REMOVAL .
Remove the two screws from the CHMSL (1) unit and remove the unit from the liftgate spoiler assembly.