LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2011 >> Journey Crew, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Seats, Front >> Pan, Seat Cushion >> Removal >> Removal

Pan, Seat Cushion: Removal: Removal

Fig 1: Seat Pan
GC0123023Courtesy of CHRYSLER LLC
NOTE:

Power seat shown in illustration, manual seat fastening locations similar.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the seat from the vehicle. Refer to SEAT, FRONT, REMOVAL  or SEAT, REMOVAL .
  3. Remove the seat back from the seat frame. Refer to PAN, SEAT CUSHION, REMOVAL .
  4. Disconnect the heated seat connector, if equipped.
  5. Remove the seat wiring harness from the seat pan.
  6. Remove four seat pan fasteners (1).
  7. Remove the seat pan from the seat adjuster.
NOTE:

If replacing the power or manual seat adjuster, remove the track stops from the front of both tracks. These stops need to be removed to snap into the same track locations on the new seat adjuster. If a stop is damaged, a new one should be ordered and installed.

scientia non olet · About LEMON Manuals