LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2009 >> Durango 4WD V8-4.7L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transfer Case >> Service and Repair >> Removal and Replacement >> NV244 GENII Transfer Case - Installation

NV244 GENII Transfer Case - Installation






INSTALLATION

1. Mount transfer case on a transmission jack.
2. Secure transfer case to jack with chains.
3. Position transfer case under vehicle.
4. Align transfer case and transmission shafts and install transfer case onto the transmission.
5. Install and tighten transfer case attaching nuts to 27-34 Nm (20-25 ft. lbs.) torque.
6. Connect the vent hose.
7. Connect the shift motor and mode sensor assembly wiring connector. Secure wire harness to clips on transfer case.
8. Align and connect the propeller shafts.Drive Shaft - Installation Drive Shaft - Installation
9. Fill transfer case with correct fluid. NV244 GENII Transfer Case - Fluid Drain and Refill
10. Install skid plate, if equipped.
11. Remove transmission jack and support stand.
12. Lower vehicle and verify transfer case shift operation.
scientia non olet · About LEMON Manuals