NV140 Transfer Case - Installation

INSTALLATION





1. Mount transfer case on a transmission jack.
2. Secure transfer case to jack with chains.
3. Position transfer case under vehicle.
4. Align transfer case (3) and transmission (1) shafts and install transfer case onto the transmission.
5. Install and tighten transfer case attaching nuts (2) to 35 Nm (26 ft. lbs.) torque.
6. Connect the transfer case vent hose.
7. Connect front propeller shaft and install rear propeller shaft. Drive Shaft - Installation




NV140 DRAIN AND FILL PLUGS





8. Fill transfer case with correct fluid. Correct as necessary.
9. Install the transfer case fill plug (1). Tighten the plug to 20-34 Nm (15-25 ft.lbs.).
10. Install rear crossmember and skid plate, if equipped. Tighten crossmember bolts to 41 Nm (30 ft. lbs.) torque.
11. Remove transmission jack and support stand.