NV244 GENII Transfer Case - Front Output Shaft Seal - Removal

REMOVAL










1. Remove the front propeller shaft Drive Shaft - Removal.
2. Remove the front propeller shaft seal boot retaining clamp (2).










3. Remove the front propeller shaft seal boot (1) from the front output shaft seal slinger (2).










4. Remove the front output shaft seal slinger (1) by bending the slinger away (2) from the transfer case.
5. Using a suitable pry tool, remove the slinger from the output shaft using care not to damage the shaft.
6. Using a screw and a slide hammer, remove the front output shaft seal.