LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2009 >> Durango 4WD V8-4.7L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transfer Case >> Seals and Gaskets >> Service and Repair >> NV244 GENII Transfer Case - Front Output Shaft Seal - Installation

NV244 GENII Transfer Case - Front Output Shaft Seal - Installation






INSTALLATION

1. Install the new front output shaft seal with Seal Installer MB991168A.
2. Install the front output shaft seal slinger with Oil Slinger Installer 8840. Install the slinger onto the shaft until the tool contacts the rear of the output shaft.
3. Install a new seal boot clamp onto the seal boot.
4. Install the seal boot and clamp onto the slinger hub and tighten the clamp with Axle Clamp Installer C-4975A.
5. Install front propeller shaftDrive Shaft - Installation.
scientia non olet · About LEMON Manuals