Installation

INSTALLATION





1. Install the upper part of the shock (1) into the frame bracket.
2. Install the nut (3) and bolt (11). Tighten to 102 Nm (75 ft. lbs.).
3. Install the lower part of the shock (1) into the lower control arm and Tighten the bolt (2) to 81 Nm (60 ft. lbs.).
4. Install the stabilizer link (7) lower nut to the lower control armFront Stabilizer Bar Link - Installation.
5. Remove the support from the lower control arm outboard end.
6. Install the tire and wheel assembly Removal and Replacement.
7. Remove the support and lower the vehicle.