LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2009 >> Durango 4WD V8-4.7L >> Repair and Diagnosis >> Steering and Suspension >> Suspension >> Control Arm >> Service and Repair >> Rear Upper Control Arm - Installation

Rear Upper Control Arm - Installation






INSTALLATION





1. Install the upper control arm (2) to the vehicle.
2. Install the upper control arm bolt and flag nut (1) at the frame.
3. Install the upper control arm bolt (3) and flag nut (4) at the axle (5).
4. Lower the vehicle to the ground and then tighten the bolts to 156 Nm (115 ft.lbs.).

scientia non olet · About LEMON Manuals