Outer Tie Rod End

OUTER TIE ROD END






NOTE: Do not twist the boot at anytime during removal or installation.

1. Thread the outer tie rod end (2) onto the inner tie rod (4), to it's original position.
2. Install the outer tie rod end into the steering knuckle (5).
3. Tighten the ball stud nut (1) on the ball stud to 75 Nm (55 ft. lbs.).
4. Set wheel toe pattern, Service and Repair.
5. Tighten jam nut (3) to 109 Nm (80 ft. lbs.).