Shaft Coupling

INSTALLATION





1. Install the upper steering coupling shaft (3) to the vehicle.

NOTE: A new steering coupling shaft pinch bolt for the upper and lower shafts must be used.

2. Install the upper coupling to the column.
3. Install the upper pinch bolt (2) use a new bolt and tighten to 38 Nm (28 ft.lbs).
4. Install the toe plate (5) nuts (4) and tighten to 12 Nm (105 in.lbs).





5. Install the shaft (1) to the lower coupling (2).
6. Install the mid point pinch bolt (3) use new bolt and tighten to 57 Nm (42 ft.lbs).
7. Unlock the steering wheel.
8. Reconnect the negative battery cable.