Pressure Hose

PRESSURE HOSE





1. Install the pressure hose (3) to the vehicle.
2. Reconnect the pressure hose (3) at the pump (1). Tighten the hose to 37 Nm (27 ft. lbs.).
3. Reconnect the return hose (4) to the gear (2). Tighten the hose to 65 Nm (48 ft. lbs.).
4. Reconnect the pressure hose (3) at the gear (2). Tighten the hose to 37 Nm (27 ft. lbs.).
5. Connect the pressure hose (3) to the crossmember retainer.
6. Remove the support and lower the vehicle.
7. Refill the power steering system,. Service and Repair