Ignition Lock Cylinder - Removal

REMOVAL





1. Disconnect negative cable from battery.
2. Remove the steering column opening cover Steering Column Opening Cover - Removal.





3. Remove the tilt lever handle.
4. Remove the lower shroud (2) from steering column.
5. Place shifter in PARK position.





The ignition key (2) must be in the key cylinder (1) for cylinder removal.

6. A retaining pin is located at side of key cylinder assembly.
a. Rotate key (2) to RUN position.
b. Press in on retaining pin with a small punch (3) , while pulling key cylinder (1) from ignition switch.





7. Remove the key (2) and key cylinder (1) from the column (3).