Second Row - Outboard

SECOND ROW - OUTBOARD

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.





1. Position the second row outboard seat belt buckle anchor (1) to the seat latch bracket (3). Be certain the anti-rotation tab on the anchor is engaged in the clearance notch of the bracket.
2. Install and tighten the nut (2) that secures the anchor to the bracket. Tighten the nut to 43 Nm (32 ft. lbs.).





3. Position the outboard seat latch bracket cover (1) onto the bracket (2).
4. Install and tighten the two screws (3) that secure the cover to the bracket. Tighten the screws to 2 Nm (20 in. lbs.).
5. Unfold and restore the outboard second row seat to its upright position.