Removal

REMOVAL - EVAP CANISTER





The EVAP canister (1) is located at the front of the fuel tank (3). The ESIM (Evaporative System Integrity Monitor) switch (2) is attached to the EVAP canister.





1. If equipped, remove the fuel tank skid plate.
2. Remove the electrical connector (3) at the ESIM switch.
3. Disconnect the rubber hose (2) from the ESIM switch.
4. Disconnect the quick-connect fitting (5) at the EVAP canister.





5. Three locking tabs are used to mount the canister (2) to its bracket, an upper tab, lower tab and an outer side tab. Press on the lower and the upper locking tab (1) to unlock the canister from the mounting bracket.
6. Depress the outer (third) locking tab and slide the EVAP canister from the mounting bracket and remove the canister from the vehicle.