NV244 GENII Transfer Case - Fluid Drain and Refill

FLUID DRAIN AND REFILL










NOTE: The fill (2) and drain (3) plugs are both in the rear case.

1. Raise vehicle.
2. Position drain pan under transfer case.
3. Remove drain (3) and fill (2) plugs and drain lubricant completely.
4. Install drain plug (3). Tighten plug to 20-34 Nm (15-25 ft. lbs.).
5. Remove drain pan.
6. Fill transfer case to bottom edge of fill plug opening with Mopar(R) ATF +4, Automatic Transmission fluid.
7. Install and tighten fill plug (2) to 20-34 Nm (15-25 ft. lbs.).
8. Lower vehicle.