LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2009 >> Durango 4WD V8-4.7L >> Repair and Diagnosis >> Heating and Air Conditioning >> Refrigerant Pressure Sensor / Switch >> Service and Repair >> Front A/C Pressure Transducer - Removal

Front A/C Pressure Transducer - Removal






REMOVAL






NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.

1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2).
3. Remove the A/C pressure transducer from the A/C discharge line (3).
4. Remove the O-ring seal (4) from the discharge line fitting and discard.

scientia non olet · About LEMON Manuals