Defroster Duct - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.





1. Remove the instrument panel and place it on a workbench Instrument Panel - Removal.
2. Remove the two screws (1) that secure the defroster duct (2) to the top of the instrument panel (3).





3. Remove the two screws (1) that secure the defroster duct (2) to the instrument panel wire harness support (3).
4. Remove the defroster duct from the instrument panel (4).