Engine Oil Pan - Installation

4X4





1. Clean the oil pan gasket mating surface of the bedplate and oil pan.
2. Position the oil pan gasket and pickup tube with new o-ring. Install the mounting bolt and nuts. Tighten bolt and nuts to 28 Nm (20 ft. lbs.).
3. Position the oil pan and install the mounting bolts. Tighten the mounting bolts to 15 Nm (11 ft. lbs.) in the sequence shown.










4. Install structural dust cover Structural Dust Cover - Installation.
5. Install oil filter.
6. Install front axle. Refer to DIFFERENTIAL AND DRIVELINE.
7. Lower vehicle.
8. Fill engine oil.
9. Start engine check for leaks.