Rear Cable

REAR PARK BRAKE CABLE






NOTE: Pull on the cable to ensure it is locked into place.


1. Push each cable end through the brake cable support plate hole until the cable end fitting tabs lock into place.




2. Push the cable (4) through the frame bracket.
3. Lock the left cable end fitting tabs (3) into the frame bracket hole.





4. Install the rear cables (2) into the tensioner rod behind the rear of the brake assembly (1).
5. Install the cable to the intermediate cable connector.
6. Release and remove the lock out device.
7. Perform the park brake adjustment procedure, Adjustments.
8. Remove the supports and lower the vehicle.