Rear Brake Lines

REAR BRAKE LINES





1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
2. Raise and support the vehicle.

NOTE: If brake line (6) is being replaced

3. Remove the brake line (6) from the junction block (2) at the frame, then remove the other end of the line at the caliper hose connection.

NOTE: If brake line (1) is being replaced

4. Remove the brake line (1) from the junction block (2) at the frame, then remove the other end of the line at the caliper hose connection.
5. Remove the line being replaced.