Front Hose

FRONT HOSE





1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
2. Raise and support vehicle.
3. Remove the tire and wheel assembly.
4. Loosen the brake line (1) from the brake hose (2) at the frame.





5. Remove the brake line (1) from the brake hose (3) and remove the retaining clip (2) located at the frame.





6. Remove the retaining clip from the brake hose (2).
7. Remove the brake hose banjo bolt at the caliper.
8. Remove the hose.