C-Pillar Trim Panel-Removal

REMOVAL





1. Remove the quarter glass trim panel. Quarter Trim Panel - Removal.
2. Unsnap the upper edge of the trim cover (3) from the second row outboard seat belt turning loop (1) and disengage the tab (2) on the lower edge of the cover to access the turning loop screw.





3. Remove the screw (3) that secures the seat belt turning loop (4) to the height adjuster (1) on the upper C-pillar (5).





4. Remove the screw (3).
5. Using a trim stick C-4755 or equivalent, separate the bottom edge of the trim (2) from the pillar and remove off of the upper locating tab (1).