Removal

REMOVAL

The Adjustable Pedal Motor is not serviced separately, It is serviced as an assembly within the Accelerator Pedal Sub-Assembly.
To remove the brake pedal slide:
1. Remove the C-clip from the pin.
2. Remove the pin from the pedal bracket.
3. Disconnect the electrical wiring connector from the motor.

NOTE: When replacing the components both pedal assemblies must be in the fully down position toward the floor for proper adjustment, Pedals can be moved manually by rotating the cable on the component not being replaced. New components come in the correct position until activated.

4. Remove the cable by squeezing the tabs together to remove from the motor.