Park Assist Sensor - Removal

REMOVAL






NOTE: The park assist sensors (3) and the sensor spacers (O-rings) are each available for separate service replacement. The sensor brackets (5) are bonded to and integral to the back side of the rear bumper fascia (2).

1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.

NOTE: The two outboard rear park assist sensors can be accessed for service with the rear bumper fascia installed on the vehicle.

2. For the two inboard rear park assist sensors only, remove the bumper fascia from the rear of the vehicle. Rear Bumper Fascia - Removal.
3. From the back of the fascia (2), disconnect the wire harness connector (4) from the park assist sensor (3) connector receptacle.
4. Carefully pry the sensor bracket (5) latch features (1) away from the top and bottom latch tabs of the sensor far enough to disengage the sensor from the bracket.
5. Disengage the O-ring spacer from around the circumference of the sensor membrane protrusion.